Product Name : Photovoltaic junction box (filling glue)
Product model :ZS-BOX03-ab
Main technical characteristics:
1 Maximum system voltage: DC1500V
2 Maximum working voltage: 100V
3 rated pulse voltage: 16000V
4 Current Rating: 12A
5 Pollution level: 1
6 Ambient temperature: -40°C~85°C
7 Protection level: Class II
8 Cable specifications: 4mm 2
9 Protection level: IP68
10 TUV certification standard: IEC 62790
11 Connector: ZS-CC01, certified by TUV 1500V according to IEC 62852
Steps for usage:
1 Make a ring of adhesive along the groove on the bottom of the case (black line shown below).
2 Route the busbar through the 4 threading holes on the bottom of the junction box and the junction box onto the component backplane.
3 Weld the busbar and the terminal of the junction box terminal firmly. The welded busbar should be pressed down as much as possible to ensure that the potting compound can completely cover it. Note: The 4 reflow zones are not accessible to each other.
4 Inject the potting compound into the box. The potting material must cover all the conductive parts.
Note: After filling, the rubber surface should not exceed the red surface of the figure below, otherwise it will overflow. The weight is about 35 grams
5 After the potting compound is cured, close the lid (catch the card at the 4th, front, left, and right).
6 To open the lid, use a word to force the 4 clips.
